29 Years Experience | 10 Years in Business

PROFESSIONAL MOBILE MARINE

SERVICES & REPAIRS

GET MOBILE SERVICE TODAY
0490 365 749

PROFESSIONAL MOBILE
MARINE SERVICE

At Anchor Marine Solutions, we bring professional marine servicing directly to you. With our fully equipped mobile workshop, there’s no need to trailer your boat to a workshop – we come to your manira, home or wherever your vessel is located.

Our owner-operator Kristian Eyles brings 29 years of mechanical expertise and 10 years of dedicated marine service experience to every job. We pride ourselves on quality workmanship, competitive pricing, and exceptional customer service.

Comprehensive Marine Services

Engine
Servicing

Outboard Engines

  • Yamaha
  • Suzuki
  • Mercury
  • Evinrude

Inboard Engines

  • Mercruiser
  • Yanmar
  • Volvo
  • Cummins

Boat
Servicing

  • Generator Motors and & Powerplants
  • Fuel systems
  • Fiberglass repairs
  • Cut & polishing
  • Detailing & trimming
  • Antifouling
  • Boat management
  • Deck equipment

Electrical
Services

  • 12v, 24v, 240v wiring
  • GPS & depth sounder installation
  • VFH & UHF marine radio
  • Stereo & entertainment systems
  • Battery testing & replacement
  • LED Lighting installations
  • Fridges & diesel heaters
  • Battery Monitors

Trailer
Servicing

  • Trailer bearings & brakes
  • Suspension & tyres
  • Tail light wiring
  • Electric brakes
  • New trailers

Plumbing
Systems

  • Toilet & grey water systems
  • Freshwater systems & Tanks
  • Shower, pumps, deck wash
  • Evinrude

Winterizing
Engine

  • Drain all water from the engine and systems
  • Flush the engine with anti-corrosion fluid
  • Stabilise fuel with a fuel stabiliser
  • Check or change engine oil
  • Fog the cylinders with fogging oil
  • Lubricate all moving parts (cables, steering, hinges)
  • Inspect and protect the battery
  • Check all electrical systems and wiring
  • Clean and dry the interior
  • Cover the boat securely with a breathable cover

FAQ

Why Winterise Your Vessel?

Protect your investment before the cold sets in.

Winterising is a thorough end-of-season check that drains all water from the engine and systems, stabilises fuel, protects the battery, and prevents corrosion — effectively a service without oils and filters.

A fishing line caught behind a propeller can damage the output shaft seal, allowing water into the gearbox. Water sitting in the gearbox over winter causes rust on bearings, gears, and shafts — leading to full destruction.

Repair cost if missed: $4,000 – $6,000 — and likely not ready for summer.

Found at winterising: Drain, replace gear oil, new seal — around $30.

Essential winterisation steps

Each area below is checked and serviced during your winterisation:

Engine protection

Drain all water from the engine block, manifolds, and hoses. Flush raw-water cooling with marine anti-corrosion fluid. Spray fogging oil into cylinders to prevent rust.

Fuel & oil

Add a high-quality fuel stabiliser to prevent ethanol issues. Check or change engine oil and lower-unit gear lube, inspecting for water intrusion — a sign of worn seals.

Electrical

Clean, fully charge, and disconnect batteries — or remove for storage. Remove electronics. Use a ScanTool to check for engine fault codes. Inspect for electrical and water damage.

Interior & hull

Clean thoroughly to prevent mildew. Use moisture absorbers. Apply corrosion guard to the engine. Check and replace anodes. Store outboard/stern drive leg in the down position to allow full drainage.

Pest protection

Inspect the cabin and hull for rodents, ants, and bugs. Apply rodent deterrents as needed to avoid costly interior damage over winter.

Pre-summer service

At the end of winter, a minor pre-summer check resolves issues early — ensuring your vessel is launch-ready on time for the season.

Ready for
Professional Marine Service

Mobile Service Available • On-Site Repairs & Maintenance • Professional • Reliable • Experienced

Copyright 2026 Anchor Marine Solutions. All Rights Reserved

Web Design By: Netwizard Design